Home Forums Mistika VR Features Request pre-roll needed using h265 source files

This topic contains 0 replies, has 1 voice, and was last updated by  fixer 1 month, 1 week ago.

  • Creator
    Topic
  • #39331

    fixer
    Participant

    I am reading in h265 files from an Obsidian S (3000×3000 mov).  If I set my in & out points within the timeline, it’s unlikely that I will hit exactly on an i-frame, making the first 10-20 frames of my export unuseable.  If I am exporting a short range to fix as an insert edit, it means I cannot add 30 frames of pre-roll myself since those now bad frames would be overwriting previously good frames (example: initial export of 0001-1000 with a revision on range of 300-350 to overwrite the previous frames)

    I would ask that MistikaVR started internally decoding the GOP at the i-frame previous to my IN point, so the first frame exported is properly decoded.

     

You must be logged in to reply to this topic.